欢迎您访问章丘随缘搬家服务有限公司网站!

咨询电话:13869155118
当前位置:首页>新闻中心>公司动态>空调移机的步骤以及注意事项

空调移机的步骤以及注意事项

文章作者:admin 来源:http://www.zqsybj.com/ 发布时间:22022-05-20 浏览次数:
空调移机的步骤
Steps of air conditioner relocation
1、前期准备:转运人员在门口拆机,并带上全套工具和安全设备。
1. Preliminary preparation: the transfer personnel dismantle the machine at the door and bring a full set of tools and safety equipment.
2、回收冷媒:先开启制冷系统,室外机运行后关闭小阀门,阀门结霜后关闭大阀门,立即停机。拔掉电源,拧紧安全帽,使空调移机中的冷媒收集到室外机中。
2. Recovery of refrigerant: start the refrigeration system first, close the small valve after the outdoor unit operates, close the large valve after the valve frosts, and shut down immediately. Unplug the power supply and tighten the safety helmet to collect the refrigerant in the air conditioner to the outdoor unit.
3、拆卸室内机:拆卸室内机时,要防止冷凝水流入电路板。
3. Disassembly of indoor unit: when disassembling the indoor unit, prevent condensate from flowing into the circuit board.
4、拆装室外机:拆装室外机时,要注意平衡,在拆卸室外机时要注意平衡,避免震动和晃动,最后用塑料包好,便于搬运。
4. Disassembly and assembly of outdoor unit: when disassembling and assembling the outdoor unit, pay attention to balance. When disassembling the outdoor unit, pay attention to balance to avoid vibration and shaking. Finally, wrap it with plastic for easy handling.
5、安装:重新安装空调时,要注意安装位置和对流。最后用清洁剂进行检漏,观察各接头是否有气泡冒出,确认系统无泄漏后,拧紧阀门安全帽。
5. Installation: when reinstalling the air conditioner, pay attention to the installation position and convection. Finally, conduct leak detection with detergent, observe whether there are bubbles at each joint, and tighten the valve safety helmet after confirming that there is no leakage in the system.
空调移机的注意事项
Precautions for air conditioner relocation
1、试机:在搬家前先测试空调的功能,看运转是否正常。
1. Commissioning: test the function of the air conditioner before moving to see if it operates normally.
2、回收制冷剂,拆除室内外连接管路。因此,如果连接线的两端有标记,在机器安装时就不会出现连接线因错误连接而失效的问题。
2. Recover the refrigerant and remove the indoor and outdoor connecting pipes. Therefore, if the two ends of the connecting line are marked, the problem of failure of the connecting line due to wrong connection will not occur during machine installation.
章丘空调移机维修
3、连接管接口的清洁:空调使用后会有灰尘和污垢。拆卸连接管接口螺母时,注意清洁喇叭口和接头,防止灰尘等污物进入管道,避免移动机器。管道在运行过程中被阻塞。安装对接接口前,需要再次检查喇叭口和内侧,清洁后将螺母合上即可。如果碰巧下雨,那么在拆卸连接管时,用塑料袋将管口包好,防止雨水进入造成冰堵。
3. Cleaning of connecting pipe interface: there will be dust and dirt after the air conditioner is used. When removing the connecting pipe interface nut, pay attention to clean the bell mouth and joint to prevent dirt such as dust from entering the pipe and avoid moving the machine. The pipeline was blocked during operation. Before installing the butt joint, check the bell mouth and inner side again, and close the nut after cleaning. If it happens to rain, wrap the pipe orifice with plastic bags when removing the connecting pipe to prevent rainwater from entering and causing ice blockage.
4.拆卸室内机时,避免冷凝水流入电路板:因为室内机的接水盘和排水管中有一些冷凝水,在拆卸室内机和运输室内机时,不要将电路板安装到室内机上。头部朝下,或翻转。需要将带电路板的一端稍高一些,水可以从另一端流出,以免冷凝水倒进电路板,导致开机时出现电气故障。
4. When disassembling the indoor unit, avoid the condensed water from flowing into the circuit board: because there is some condensed water in the water receiving tray and drainage pipe of the indoor unit, do not install the circuit board on the indoor unit when disassembling the indoor unit and transporting the indoor unit. Head down, or flip. It is necessary to raise one end of the circuit board slightly, and the water can flow out from the other end, so as not to pour condensate into the circuit board, resulting in electrical failure during startup.
5、检查连接口的喇叭口:由于连接管上的喇叭口被长时间挤压,有些喇叭口的根部有很深的压痕。这些喇叭口很容易折断和拉断,或者开机时有漏气,所以喇叭口需要拆开检查,不合格的需要剪掉重新扩口,以免隐患。
5. Check the bell mouth of the connecting port: because the bell mouth on the connecting pipe is squeezed for a long time, there are deep indentation at the root of some bell mouths. These flares are easy to break and pull off, or there is air leakage when starting up, so the flares need to be disassembled for inspection. Unqualified ones need to be cut off and flared again to avoid hidden dangers.
6、章丘空调移机维修人员提醒您,外机在运输和安装过程中,不准翻倒,或有过大的倾角,用手抓紧截止阀也不能起吊。另外,搬运机器时,注意轻拿轻放,拆装过程科学,拔管方向合理,抗弯强度合适。
6. The maintenance personnel of Zhangqiu air conditioner remind you that during the transportation and installation of the external unit, it is not allowed to overturn or have too large inclination angle. You can't lift the stop valve by hand. In addition, when handling the machine, pay attention to handle it gently, the disassembly process is scientific, the pulling direction is reasonable, and the bending strength is appropriate.
空调移机的步骤以及注意事项便是这样了,您想了解更多内容就来关注我们的网站www.zqsybj.com吧!
The steps and precautions of air conditioner relocation are like this. If you want to know more, please pay attention to our website www.zqsybj.com Com!

相关产品 / Related products